Difficulty

Easy

Steps

6

Time Required

                          10 minutes

Sections

1

  • Battery
  • 6 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackVorwerk Kobold VR200

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Turn off robot
  • Turn off the robot via the “Settings” > “Turn off robot” menu.

Turn off the robot via the “Settings” > “Turn off robot” menu.

1024

Step 2

              Turn the Robot
  • Turn the robot over and place it on a suitable, soft surface. Make sure that the robot does not lie directly on the dome.
  • Use either two soft wooden slats or a small and sturdy cardboard box.

Turn the robot over and place it on a suitable, soft surface. Make sure that the robot does not lie directly on the dome.

Use either two soft wooden slats or a small and sturdy cardboard box.

Step 3

              Remove Torx Screws
  • Now remove the two screws 3.5x14mm with a Torx screwdriver T10

Now remove the two screws 3.5x14mm with a Torx screwdriver T10

Step 4

              Remove Battery Cover
  • Now pry open the battery cover with a suitable tool (plectrum or plastic opening tool). Make sure that there are two latches on the opposite side of the screws. The cover must therefore be lifted from the screw-on side.

Now pry open the battery cover with a suitable tool (plectrum or plastic opening tool). Make sure that there are two latches on the opposite side of the screws. The cover must therefore be lifted from the screw-on side.

Step 5

              Remove the Battery
  • Removing the battery is a bit difficult. One possibility is that you use the plastic opening tool to remove the foam tape on the left and right side of the battery.
  • Then you can use both hands to lift the battery by the “ears” of the tape.

Removing the battery is a bit difficult. One possibility is that you use the plastic opening tool to remove the foam tape on the left and right side of the battery.

Then you can use both hands to lift the battery by the “ears” of the tape.

Step 6

              Disconnect the Battery
  • Disconnect the 4-pin plug of the battery by first pressing the latch and then pulling out the plug.

Disconnect the 4-pin plug of the battery by first pressing the latch and then pulling out the plug.

Now the replacement battery can be connected!

Work the steps in reverse order to reassemble your device.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             


        oldturkey03 is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

oldturkey03

Author

                                      with 1 other contributor 


                    Pixel-Pete

Member since: 04/25/2022

193 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges