Difficulty
Difficult
Steps
6
Time Required
15 minutes
Sections
2
- Base
- 2 steps
- Base Fuse
- 4 steps
Flags
0
BackVTech CS6719-2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Base
- Remove the four Phillips #0 screws (9.4mm) located at the bottom of the phone on the back side of the base.
Remove the four Phillips #0 screws (9.4mm) located at the bottom of the phone on the back side of the base.
1024
Step 2
- Use the spudger to separate the bottom from the top.
- There are two clips, located top and bottom, that you have to compress with the spudger.
Use the spudger to separate the bottom from the top.
There are two clips, located top and bottom, that you have to compress with the spudger.
Step 3
Base Fuse
- Locate the fuse.
Locate the fuse.
Step 4
- Flip the board over.
- Remember where the fuse is located.
Flip the board over.
Remember where the fuse is located.
Step 5
- Refer to the guide on How To Solder and Desolder Connections.
Refer to the guide on How To Solder and Desolder Connections.
Step 6
- Flip the board back over and remove the fuse.
Flip the board back over and remove the fuse.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 6 other contributors
Nick Boyd
Member since: 02/08/2016
285 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
IUPUI, Team 1-4, Baechle Spring 2016
Member of IUPUI, Team 1-4, Baechle Spring 2016
IUPUI-BAECHLE-S16S1G4
4 Members
16 Guides authored
