Difficulty

Difficult

Steps

6

Time Required

                          15 minutes

Sections

2

  • Base
  • 2 steps
  • Charging Wire
  • 4 steps

Flags

5

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

  • BackVTech CS6719-2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Base
  • Remove the four Phillips #0 screws (9.4mm) located at the bottom of the phone on the back side of the base.

Remove the four Phillips #0 screws (9.4mm) located at the bottom of the phone on the back side of the base.

1024

Step 2

  • Use the spudger to separate the bottom from the top.
  • There are two clips, located top and bottom, that you have to compress with the spudger.

Use the spudger to separate the bottom from the top.

There are two clips, located top and bottom, that you have to compress with the spudger.

Step 3

              Charging Wire
  • Heat up solder joint on the circuit board where the charging wires are connected. Note: This is the CRD- and CRD+ terminals.

Heat up solder joint on the circuit board where the charging wires are connected. Note: This is the CRD- and CRD+ terminals.

Step 4

  • Refer to How to Solder and Desolder connections How To Solder and Desolder Connections
  • Note: Ensure the old solder joint is removed.
  • Caution: Soldering iron and joint will become very hot.

Refer to How to Solder and Desolder connections How To Solder and Desolder Connections

Note: Ensure the old solder joint is removed.

Caution: Soldering iron and joint will become very hot.

Step 5

  • Heat up solder joint on the base unit where the charging wires are connected.

Heat up solder joint on the base unit where the charging wires are connected.

Step 6

  • Take a wire of solder and apply to joint on board to remove the extra solder.
  • Note: Ensure the old solder joint is removed.
  • Caution: Soldering iron and joint will become very hot.
  • Remove charging wire connection.

Take a wire of solder and apply to joint on board to remove the extra solder.

Remove charging wire connection.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Josh Showalter

Member since: 02/08/2016

442 Reputation

                                      3 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

Team

                       IUPUI, Team 1-4, Baechle Spring 2016                        

                                                  Member of IUPUI, Team 1-4, Baechle Spring 2016 



                    IUPUI-BAECHLE-S16S1G4                     


                                            4 Members                     


                                            16 Guides authored