Difficulty
Moderate
Steps
10
Time Required
Suggest a time??
Sections
2
- Back Panel
- 5 steps
- Motherboard
- 5 steps
Flags
0
BackVTech InnoTab 2s
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Turn your device to where the back panel is facing you.
Turn your device to where the back panel is facing you.
1024
Step 2
- Lift the Leg all the way up and twist the bottom to remove.
- Once the bottom part pops out the whole leg should just come off.
- Remove any game cartridge from the device.
Lift the Leg all the way up and twist the bottom to remove.
Once the bottom part pops out the whole leg should just come off.
Remove any game cartridge from the device.
Step 3
- Remove all of the plastic tabs on the device. These are covering screws that will need to be removed.
- These covers are made of hard plastic so they may be difficult to remove.
- There is a special tab in the cartridge cover that is made of rubber, make sure to not break this tab.
Remove all of the plastic tabs on the device. These are covering screws that will need to be removed.
These covers are made of hard plastic so they may be difficult to remove.
There is a special tab in the cartridge cover that is made of rubber, make sure to not break this tab.
Step 4
- Remove all nine screws from the back of the device using a J0 bit.
- Remove the small battery.
Remove all nine screws from the back of the device using a J0 bit.
Remove the small battery.
Step 5
- Using a plastic opening tool, detach the backplate from the front piece.
- Do not use excessive force. Double check that you removed all the screws if the panel is not coming off easily.
- Once the backplate has been removed, you will have access to the circuit board.
Using a plastic opening tool, detach the backplate from the front piece.
Do not use excessive force. Double check that you removed all the screws if the panel is not coming off easily.
Once the backplate has been removed, you will have access to the circuit board.
Step 6
Motherboard
- First begin by removing the three cross-head screws using a J0 bit.
First begin by removing the three cross-head screws using a J0 bit.
Step 7
- First remove the ribbon cables. There are two highlighted by the red squares
- Do not apply too much pressure and make sure that the black plastic tabs are fully open before you pull the cable out.
First remove the ribbon cables. There are two highlighted by the red squares
Do not apply too much pressure and make sure that the black plastic tabs are fully open before you pull the cable out.
Step 8
- Remove the camera from the assembly and put is a safe place so that it will not get damaged.
Remove the camera from the assembly and put is a safe place so that it will not get damaged.
Step 9
- Remove the board from the main assembly.
- Be careful not to pull too hard so that the cables aren’t broken.
Remove the board from the main assembly.
Be careful not to pull too hard so that the cables aren’t broken.
Step 10
- De-solder the points shown to fully remove the cables and free the board.
- A soldering guide offered by IFIXIT can be found here Soldering Skills.
De-solder the points shown to fully remove the cables and free the board.
A soldering guide offered by IFIXIT can be found here Soldering Skills.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Ricardo Espinosa
Member since: 10/06/2016
221 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
USF Tampa, Team 5-1, Lacy Fall 2016
Member of USF Tampa, Team 5-1, Lacy Fall 2016
USFT-LACY-F16S5G1
4 Members
6 Guides authored
