Difficulty
Easy
Steps
14
Time Required
10 minutes
Sections
2
- Back Panel
- 6 steps
- Green Cymbal
- 8 steps
Flags
0
BackVtech Kidibeats Drum Set
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Locate the battery panel that is centered between the three leg supports at the bottom of the drum set.
Locate the battery panel that is centered between the three leg supports at the bottom of the drum set.
1024
Step 2
- To remove the battery panel, loosen the 10 mm panel screw using a flathead 4.0 screwdriver.
- You can also use a small coin to loosen the screw.
To remove the battery panel, loosen the 10 mm panel screw using a flathead 4.0 screwdriver.
You can also use a small coin to loosen the screw.
Step 3
- Using your fingers, pry open and remove the back battery panel.
Using your fingers, pry open and remove the back battery panel.
Step 4
- Use your fingers to remove each battery from its housing.
Use your fingers to remove each battery from its housing.
Step 5
- Using a Phillips #2 screwdriver, loosen and remove the six 14 mm screws.
Using a Phillips #2 screwdriver, loosen and remove the six 14 mm screws.
Step 6
- With your hands, separate the bottom panel from the drum set.
- When removing the bottom panel, be careful not to pull too hard in order to prevent damaging the connections from the motherboard to the speaker and power source.
With your hands, separate the bottom panel from the drum set.
When removing the bottom panel, be careful not to pull too hard in order to prevent damaging the connections from the motherboard to the speaker and power source.
Step 7
Green Cymbal
- Use Phillips #2 screwdriver to loosen and remove the single 16 mm screw.
Use Phillips #2 screwdriver to loosen and remove the single 16 mm screw.
Step 8
- Using your hands, remove the blue cymbal stand from the orange base.
Using your hands, remove the blue cymbal stand from the orange base.
Step 9
- Loosen and remove the two 14 mm screws using a Phillips #2 screwdriver.
Loosen and remove the two 14 mm screws using a Phillips #2 screwdriver.
Step 10
- Using your hands, separate the two halves of the blue cymbal stand.
Using your hands, separate the two halves of the blue cymbal stand.
Step 11
- Using your hands, separate the green cymbal from the blue cymbal base.
Using your hands, separate the green cymbal from the blue cymbal base.
Step 12
- Using a Phillips #00 screwdriver, loosen and remove the three 12 mm screws located on the bottom of the green cymbal.
Using a Phillips #00 screwdriver, loosen and remove the three 12 mm screws located on the bottom of the green cymbal.
Step 13
- Using your hands, separate the green cymbal from the green cymbal base.
Using your hands, separate the green cymbal from the green cymbal base.
Step 14
- Using your hands, pull apart the green cymbal from the yellow light casing.
Using your hands, pull apart the green cymbal from the yellow light casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Aaron Klementowski
Member since: 02/09/2016
820 Reputation
6 Guides authored
Badges:
12
+9 more badges
Team
USF Tampa, Team 2-8, Cagle Spring 2016
Member of USF Tampa, Team 2-8, Cagle Spring 2016
USFT-CAGLE-S16S2G8
2 Members
6 Guides authored
