Vtech Kidibeats Drum Set Speaker Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          15 minutes

Sections

Back Panel
6 steps
Speaker
3 steps

Flags

Featured Student Guide

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

BackVtech Kidibeats Drum Set
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Locate the battery panel that is centered between the three leg supports at the bottom of the drum set.

Locate the battery panel that is centered between the three leg supports at the bottom of the drum set.

1024

Step 2

To remove the battery panel, loosen the 10 mm panel screw using a flathead 4.0 screwdriver.
You can also use a small coin to loosen the screw.

To remove the battery panel, loosen the 10 mm panel screw using a flathead 4.0 screwdriver.

You can also use a small coin to loosen the screw.

Step 3

Using your fingers, pry open and remove the back battery panel.

Using your fingers, pry open and remove the back battery panel.

Step 4

Use your fingers to remove each battery from its housing.

Use your fingers to remove each battery from its housing.

Step 5

Using a Phillips #2 screwdriver, loosen and remove the six 14 mm screws.

Using a Phillips #2 screwdriver, loosen and remove the six 14 mm screws.

Step 6

With your hands, separate the bottom panel from the drum set.
When removing the bottom panel, be careful not to pull too hard in order to prevent damaging the connections from the motherboard to the speaker and power source.

With your hands, separate the bottom panel from the drum set.

When removing the bottom panel, be careful not to pull too hard in order to prevent damaging the connections from the motherboard to the speaker and power source.

Step 7

              Speaker

Loosen and remove the two 10mm screws using a Phillips #00 screwdriver.

Loosen and remove the two 10mm screws using a Phillips #00 screwdriver.

Step 8

Using your hand, gently remove speaker from its housing.

Using your hand, gently remove speaker from its housing.

Step 9

Using a soldering station, carefully desolder the connection points on the speaker.
To review soldering safety and techniques, please visit How To Solder and Desolder Connections.

Using a soldering station, carefully desolder the connection points on the speaker.

To review soldering safety and techniques, please visit How To Solder and Desolder Connections.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor

                    Aaron Klementowski

Member since: 02/09/2016

820 Reputation

                                      6 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       USF Tampa, Team 2-8, Cagle Spring 2016                        

                                                  Member of USF Tampa, Team 2-8, Cagle Spring 2016 



                    USFT-CAGLE-S16S2G8                     


                                            2 Members                     


                                            6 Guides authored

Featured Student Guide#

Introduction#

What you need#

Team#

Featured Student Guide

Introduction

What you need

Team