Vtech Kidizoom Camera Connect Shutter Button Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          10 minutes            

Sections

2

• Front Case
• 4 steps
• Shutter Button
• 3 steps

Flags

0

• BackVTech Kidizoom Camera Connect

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Front Case               

• Remove batteries and SD card before beginning disassembly!
• Locate the four plastic screw covers denoted by the markers and gently pry them up with the metal spudger.

Remove batteries and SD card before beginning disassembly!

Locate the four plastic screw covers denoted by the markers and gently pry them up with the metal spudger.

1024

Step 2

• Remove all four (11mm) screws with the Philips #0 screwdriver.

Remove all four (11mm) screws with the Philips #0 screwdriver.

Step 3

• Remove the two battery cartridges located on the underside of the camera.
• Once cartridges are removed, use the metal spudger to pry open the top, bottom, and both sides of the camera.

Remove the two battery cartridges located on the underside of the camera.

Once cartridges are removed, use the metal spudger to pry open the top, bottom, and both sides of the camera.

Step 4

• Beware of the two black viewfinder lens falling out as you pry open the device!
• The device should now be open and ready for further repair and/or replacement parts.

Beware of the two black viewfinder lens falling out as you pry open the device!

The device should now be open and ready for further repair and/or replacement parts.

Step 5

              Shutter Button               

• Remove the purple plastic that covers the button and circuit board. It should slide right out from the slot it sits in.

Remove the purple plastic that covers the button and circuit board. It should slide right out from the slot it sits in.

Step 6

• Unsolder wires connected to the right side of the circuit board. Pull the wires to the side.

Unsolder wires connected to the right side of the circuit board. Pull the wires to the side.

Step 7

• The button/circuit board should be loose now. Gently pull out the button/circuit board to remove it from the device.

The button/circuit board should be loose now. Gently pull out the button/circuit board to remove it from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Justin Sanchez                     

Member since: 02/08/2016

493 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       USF Tampa, Team 6-4, Eyestone Spring 2016                        

                                                  Member of USF Tampa, Team 6-4, Eyestone Spring 2016 



                    USFT-EYESTONE-S16S6G4                     


                                            4 Members                     


                                            5 Guides authored