Difficulty
Moderate
Steps
3
Time Required
8 minutes
Sections
1
- Whammy Bar
- 3 steps
Flags
0
BackVTech Record and Learn KidiStudio
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Whammy Bar
- Unscrew 11 PH2 screws (7 mm).
- Remove black plastic backing.
- Remove the batteries from the toy before beginning replacement of the whammy bar.
Unscrew 11 PH2 screws (7 mm).
Remove black plastic backing.
Remove the batteries from the toy before beginning replacement of the whammy bar.
1024
Step 2
- Remove PH2 screw (5 mm) from yellow/gold colored circuit board and pull back to access the whammy component.
Remove PH2 screw (5 mm) from yellow/gold colored circuit board and pull back to access the whammy component.
Step 3
- Remove 3 PH2 (5 mm) screws connected to the whammy bar component.
- Remove blue piece from back of the device. This will free the whammy bar. Replace the whammy bar with new part.
Remove 3 PH2 (5 mm) screws connected to the whammy bar component.
Remove blue piece from back of the device. This will free the whammy bar. Replace the whammy bar with new part.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Shaina Carbonel
Member since: 02/01/2016
537 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
UW Tacoma, Team 1-1, Rose Winter 2016
Member of UW Tacoma, Team 1-1, Rose Winter 2016
UWT-ROSE-W16S1G1
5 Members
5 Guides authored
