Vtech Spin And Learn Color Flashlight Red Ring Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Battery Housing
1 step
Red Ring
2 steps

Flags

BackVTech Spin and Learn Color Flashlight
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery Housing

Locate the battery housing on the back of the flashlight as pictured.
Unscrew the single 8 mm Phillips #1 screw.
The screw will stay attached to the cover that will be removed.
Lift the battery housing cover to reveal the battery terminals. Remove the batteries.

Locate the battery housing on the back of the flashlight as pictured.

Unscrew the single 8 mm Phillips #1 screw.

The screw will stay attached to the cover that will be removed.

Lift the battery housing cover to reveal the battery terminals. Remove the batteries.

1024

Step 2

              Red Ring

Locate the screw covering stickers on the side of the red ring. These two stickers will be slightly larger than the normal stickers. In this case it was a ladybug and a duck on opposite sides of the ring.
With a plastic opening tool, gently remove the stickers by prying around the edges. Be careful with these as you will want to reapply them later

Locate the screw covering stickers on the side of the red ring. These two stickers will be slightly larger than the normal stickers. In this case it was a ladybug and a duck on opposite sides of the ring.

With a plastic opening tool, gently remove the stickers by prying around the edges. Be careful with these as you will want to reapply them later

Step 3

Remove the two 8mm Phillips #0 screws from the screw channels found under the stickers in step one. This can be seen in the first photo if step 2.
Once the screws have been successfully removed, grasp one half of the ring and pull gently to separate it from the yellow housing. Repeat on the opposite side and the ring is disassembled.

Remove the two 8mm Phillips #0 screws from the screw channels found under the stickers in step one. This can be seen in the first photo if step 2.

Once the screws have been successfully removed, grasp one half of the ring and pull gently to separate it from the yellow housing. Repeat on the opposite side and the ring is disassembled.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Nathaniel Troyer

Member since: 08/27/2015

441 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       USF Tampa, Team 2-6, Blackwell Fall 2015                        

                                                  Member of USF Tampa, Team 2-6, Blackwell Fall 2015 



                    USFT-BLACKWELL-F15S2G6                     


                                            3 Members                     


                                            9 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team