Difficulty
Easy
Steps
5
Time Required
Suggest a time??
Sections
2
- Battery
- 3 steps
- Power Switch
- 2 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
Missing Details
Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.
BackVTech Touch and Swipe Baby Phone
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Battery
- Using a Phillips #1 screwdriver, remove the 4.8mm screw on the battery cover by twisting the screwdriver counter-clockwise.
Using a Phillips #1 screwdriver, remove the 4.8mm screw on the battery cover by twisting the screwdriver counter-clockwise.
1024
Step 2
- Remove the two AAA batteries by pulling on one end of the battery and lifting it straight out.
Remove the two AAA batteries by pulling on one end of the battery and lifting it straight out.
Step 3
- When reassembling, align the notch on the battery panel with the slot on the phone.
When reassembling, align the notch on the battery panel with the slot on the phone.
Step 4
Power Switch
- Remove 4 13.8mm screws holding the device back using a Phillips #1 screw driver.
Remove 4 13.8mm screws holding the device back using a Phillips #1 screw driver.
Step 5
- Lift directly up to remove the switch and lay the wire down to the side.
- Once the switch has been taken out you can remove the switch’s casing.
Lift directly up to remove the switch and lay the wire down to the side.
Once the switch has been taken out you can remove the switch’s casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
tellocordova
Member since: 09/04/2015
342 Reputation
2 Guides authored
Badges:
10
+7 more badges
Team
USF Tampa, Team 2-4, Sullivan Fall 2015
Member of USF Tampa, Team 2-4, Sullivan Fall 2015
USFT-SULLIVAN-F15S2G4
3 Members
6 Guides authored
Schwarzstein - Jul 21, 2016
Reply
Good work.
I have done it the same way,
the wire at the switch was bad soldered,
but it was easy to repair it and i soldered it new.
Nice.
shakinsher - May 22, 2018
Reply
My baby’s phone keeps turning itself off. The switch is in the ON position but it keeps turning OFF and singing the off song. I have opened the phone and even held the switch to ON but it still keeps turning OFF even without the switch moving. Any suggestions?