Vtech Write And Learn Creative Center Speaker Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Back Panel
1 step
Speaker
2 steps

Flags

BackVTech Write and Learn Creative Center
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Remove all eleven 9mm PH 2 Phillips screws securing the back of the case.

Remove all eleven 9mm PH 2 Phillips screws securing the back of the case.

1024

Step 2

              Speaker

In order to remove the speaker, you must desolder the two wires connecting it to the circuit board.
When you desolder, apply the tip of the soldering iron to the soldered joint for approximately 5 - 10 seconds.
The soldered joint will turn to a liquid consistency. At this moment, remove the wire and soldering iron.
Repeat each of the following steps for the second soldered joint.
Soldering irons are dangerously hot. The soldering iron should only come in contact with joints being desoldered or soldered.
Make sure to allow time for your soldering iron to heat up before using it.
Make sure the tip of the soldering iron is cleaned so the tin on the tip is exposed. This will allow the soldering iron to work efficiently.

In order to remove the speaker, you must desolder the two wires connecting it to the circuit board.

When you desolder, apply the tip of the soldering iron to the soldered joint for approximately 5 - 10 seconds.

The soldered joint will turn to a liquid consistency. At this moment, remove the wire and soldering iron.

Repeat each of the following steps for the second soldered joint.

Soldering irons are dangerously hot. The soldering iron should only come in contact with joints being desoldered or soldered.

Make sure to allow time for your soldering iron to heat up before using it.

Make sure the tip of the soldering iron is cleaned so the tin on the tip is exposed. This will allow the soldering iron to work efficiently.

Step 3

Remove the 2 5mm PH 0 Phillips screws with 10 mm heads that secure the speaker to the front of the case.

Remove the 2 5mm PH 0 Phillips screws with 10 mm heads that secure the speaker to the front of the case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Victoria Hathaway

Member since: 04/06/2016

310 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team 1-2, Miles Spring 2016                        

                                                  Member of UMass Dartmouth, Team 1-2, Miles Spring 2016 



                    UMASSD-MILES-S16S1G2                     


                                            3 Members                     


                                            6 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team