Difficulty
Moderate
Steps
6
Time Required
5 minutes
Sections
2
- Back Panel
- 2 steps
- I/O Board
- 4 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackVulcan Venture II VNB14002IE
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Back Panel
- Use a J00 screwdriver to unscrew the 10 back-plate screws.
Use a J00 screwdriver to unscrew the 10 back-plate screws.
1024
Step 2
- Using light pressure, slowly wiggle off the back panel.
Using light pressure, slowly wiggle off the back panel.
Step 3
I/O Board
- Locate the IO board on the back panel.
Locate the IO board on the back panel.
Step 4
- Locate the ribbon connector on the IO board, and lift the black bar closest the the ribbon.
- Pull the ribbon cable away from the connector, releasing it.
Locate the ribbon connector on the IO board, and lift the black bar closest the the ribbon.
Pull the ribbon cable away from the connector, releasing it.
Step 5
- Locate the screws on the IO panel, and use the J00+ bit to unscrew them.
Locate the screws on the IO panel, and use the J00+ bit to unscrew them.
Step 6
- The IO Board is now safe to remove from the computer.
The IO Board is now safe to remove from the computer.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Parish Brandt
Member since: 09/21/2018
615 Reputation
5 Guides authored
Badges:
5
+2 more badges
Team
University of North Texas, Team S1-G5, Riccardelli Fall 2018
Member of University of North Texas, Team S1-G5, Riccardelli Fall 2018
UNT-RICCARDELLI-F18S1G5
4 Members
7 Guides authored