Difficulty

Easy

Steps

11

Time Required

                          5 minutes

Sections

2

  • Case
  • 8 steps
  • Power Cord
  • 3 steps

Flags

0

  • BackWahl Chrome Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Case
  • Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.
  • Make sure your device is not connected to power before you begin.

Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.

Make sure your device is not connected to power before you begin.

1024

Step 2

  • Lift the bottom blade straight up from the device body to remove it.

Lift the bottom blade straight up from the device body to remove it.

Step 3

  • Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.

Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.

Step 4

  • Lift the base of blade assembly straight up off of the body.

Lift the base of blade assembly straight up off of the body.

Step 5

  • Remove the two 12.0 mm JIS #1 screws on the back of the device body.

Remove the two 12.0 mm JIS #1 screws on the back of the device body.

Step 6

  • Remove the 13.0 mm Phillips #2 screw on the side of the device body.
  • This screw is located on the opposite side of the body from the switch.

Remove the 13.0 mm Phillips #2 screw on the side of the device body.

This screw is located on the opposite side of the body from the switch.

Step 7

  • Remove the spring on the side of the body using tweezers.

Remove the spring on the side of the body using tweezers.

Step 8

  • Pry the body case off of the device using a spudger.

Pry the body case off of the device using a spudger.

Step 9

              Power Cord
  • Remove one 7.5 mm JIS #1 screw from the switch base.

Remove one 7.5 mm JIS #1 screw from the switch base.

Step 10

  • Unplug the cord terminal from the motor connector.

Unplug the cord terminal from the motor connector.

Step 11

  • Remove the cord from the device base by pulling gently.

Remove the cord from the device base by pulling gently.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Manuel Salazar M.

Member since: 11/07/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S7-G3, Baechle Fall 2017                        

                                                  Member of IUPUI, Team S7-G3, Baechle Fall 2017 



                    IUPUI-BAECHLE-F17S7G3                     


                                            3 Members                     


                                            4 Guides authored