Difficulty
Easy
Steps
5
Time Required
5 minutes
Sections
2
- Bottom Panel
- 2 steps
- Drive Coupling
- 3 steps
Flags
0
BackWaring 51BL29
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Bottom Panel
- Turn the blender on its side so the bottom panel is facing you.
- Unscrew the 22mm Phillips #1 screw on the indent of the panel.
- Unscrew the 3 screws in the rubber holes.
Turn the blender on its side so the bottom panel is facing you.
Unscrew the 22mm Phillips #1 screw on the indent of the panel.
Unscrew the 3 screws in the rubber holes.
1024
Step 2
- Remove the bottom panel.
Remove the bottom panel.
Step 3
Drive Coupling
- Place the screwdriver in the head of the middle flat-head screw.
Place the screwdriver in the head of the middle flat-head screw.
Step 4
- Unscrew this screw while holding the coupling with your other hand and not allowing it to rotate.
- This screw may be reverse-threaded.
Unscrew this screw while holding the coupling with your other hand and not allowing it to rotate.
This screw may be reverse-threaded.
Step 5
- Once the coupling mechanism has been loosened all the way, gently pull it off the top of the blender.
Once the coupling mechanism has been loosened all the way, gently pull it off the top of the blender.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 5 other contributors
Dean Becker
Member since: 04/17/2017
455 Reputation
4 Guides authored
Badges:
6
+3 more badges
Team
Cal Poly, Team S15-G4, Banghart Spring 2017
Member of Cal Poly, Team S15-G4, Banghart Spring 2017
CPSU-BANGHART-S17S15G4
4 Members
5 Guides authored
