Difficulty

Easy

Steps

12

Time Required

                          15 minutes

Sections

3

  • Front Panel
  • 5 steps
  • Power Cable
  • 4 steps
  • Speed Adjustment Assembly
  • 3 steps

Flags

0

  • BackWen 2307

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front Panel
  • Unscrew the locking sleeve.

Unscrew the locking sleeve.

1024

Step 2

  • Remove the hanging clip.

Remove the hanging clip.

Step 3

  • Unscrew the six 8mm PH2 screws.

Unscrew the six 8mm PH2 screws.

Step 4

  • While pressing the spindle lock button, unscrew the collet nut and remove it along with the brass collet.

While pressing the spindle lock button, unscrew the collet nut and remove it along with the brass collet.

Step 5

  • To remove the front panel, pry the device apart while holding the device with the other hand.
  • The front panel should come out easily.

To remove the front panel, pry the device apart while holding the device with the other hand.

The front panel should come out easily.

Step 6

              Power Cable
  • Identify the screws.
  • Unscrew the two 3mm phillips PH2.
  • Don’t forget to put them appart from the ones unscrewed before.
  • Don’t forget to put them appart from the ones unscrewed before.
  • Phillips PH2
  • Flathead 2.5mm

Identify the screws.

Unscrew the two 3mm phillips PH2.

Don’t forget to put them appart from the ones unscrewed before.

Phillips PH2

Flathead 2.5mm

Step 7

  • Remove the place boar carefully.

Remove the place boar carefully.

Step 8

  • Pull out the power cable connectors.

Pull out the power cable connectors.

Step 9

  • Pull out the cord sleve for the new cable replacement.

Pull out the cord sleve for the new cable replacement.

Step 10

              Speed Adjustment Assembly
  • Remove the connected wiring from the circuit board.

Remove the connected wiring from the circuit board.

Step 11

  • Remove the single 4mm screw retaining the circuit board.

Remove the single 4mm screw retaining the circuit board.

Step 12

  • Gently pry the circuit board from the back piece.

Gently pry the circuit board from the back piece.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Dominick Chavez

Member since: 02/08/2016

137 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       USF Tampa, Team 12-1, Eyestone Spring 2016                        

                                                  Member of USF Tampa, Team 12-1, Eyestone Spring 2016 



                    USFT-EYESTONE-S16S12G1                     


                                            4 Members                     


                                            6 Guides authored